6-METER ROTATABLE DIPOLE
RLD  1/20/97

PARTS LIST
QTY	DESCRIPTION						COST$
1	PVC 1" INSERT COUPLING 3.25"L (made by LASCO)		0.7900
	Drill the following three holes:
	1) 3/8"D hole in center (may need to flatten outer
	surface)
	2) 9/64"D thru-hole 1" from each end
1	BNC FEMALE BULKHEAD CONNECTOR				0.6900
2	#6 LOCKING SOLDER LUG					0.0722
	Place the lugs inside (between tubing and coupling)
2	1"L #18 AWG TINNED BUS WIRE				0.0067
2	1.5"L #6-32 S/S MACHINE SCREW				0.3750
4	#6 S/S FLAT WASHER					0.2500
2	#6 S/S LOCK WASHER					0.1250
2	#6-32 S/S HEX NUT					0.3750
1	10'L 3/4"OD ALUMINUM (TRIM) TUBING			8.9125
	Cut into two 4' 8" lengths
	Insert 1.25" into PVC coupling (leaving 0.75" gap)
	Drill four 9/64"D holes in tubing (through the holes
	in the coupling), (1/4" from end of tubing)
2	3/4"ID PLASTIC END CAPS - WHITE (Shepherd #9107)	0.3350
2	U-BOLT 4.5"L x 2.125"W ZINC 1.25PI 5/16"D
	(Crown Bolt #383)					2.0000
	Spaced 2.25" apart
1	1x4 WOOD BLOCK 4"L (0.75"THK x 3.5"W)			0.5000
	To mast mount, drill four 5/16"D thru-holes at 2.25"
	x 2.125", and route a 1/4" wide groove down the
	center of block

	TOTAL:							14.4314